When using an automatic soldering machine , a soldering iron tip is an essential consumable. So how to use the automatic soldering iron head correctly? First of all, it is necessary to choose an appropriate temperature. Excessively high temperature will weaken the function of the soldering iron tip, accelerate its oxidation, and relatively shorten the service life. In energy In the case of sufficient work, use a lower temperature as much as possible. The lower temperature can also be fully soldered, and it can protect the temperature-sensitive components separately. 350~380 度。 Generally recommended temperature is 350 ~ 380 degrees. 以下小焊点 350~360 度， 2.5mm 以上大焊点 370~380 度。 Small solder joints below 1.5mm are 350 ~ 360 degrees, and large solder joints above 2.5mm are 370 ~ 380 degrees. 220 度，让烙铁头的上锡部位充分吃锡，最 Then when using the soldering iron head for the first time, be sure to first adjust the temperature of the soldering iron head to 220 degrees, so that the upper part of the soldering iron head can eat enough tin. 5 分钟，然后在清洁海绵上擦拭干净，并把烙铁温度再次调至 300 度，重复上述程序，最后把烙铁温度调至所需使用温度进行使用。 Fortunately, soak in the tin pile for 5 minutes, then wipe it on the cleaning sponge, and adjust the temperature of the soldering iron to 300 degrees again , repeat the above procedure, and finally adjust the temperature of the soldering iron to the required use temperature. The purpose is to form a comprehensive protective film on the tin layer on the tip of the soldering iron to prevent it from being oxidized at high temperature, which will cause heat transfer failure. In order to have beautiful solder joints, in addition to the quality of the automatic soldering machine , the quality of the soldering iron tip of the automatic soldering machine must also be high! Dongguan Key Automation Equipment Co., Ltd. not only produces automatic soldering machines , but also produces automatic soldering iron tips. Friends are welcome to come to consult.