威尼斯人官网

新闻中心

Installation and routine maintenance of automatic dispensers! You are here: 威尼斯人官网 - Company News - Industry News

Installation and routine maintenance of automatic dispensers!

Release time: 2016.03.08 News source: Dispensing machine | Automatic dispensing machine | China's leading brand of automatic soldering machine | Soldering robot Browse times:

First, the installation precautions of the machine
1.The most important condition for equipment installation is that a horizontal carrier (ground or special table) places the automatic dispenser on it, and adjusts the fixed seat at the bottom of the automatic dispenser to make the work surface of the dispenser at a horizontal level. Position, fix the casters after adjusting to prevent the equipment from sliding due to inertia during operation.
  
2.After the automatic dispenser is fixed, it is connected to the power supply. The automatic dispensers currently on the market are basically powered by AC 220V. (Note that the power supply must have a ground wire. Otherwise, the entire frame of the device may have (Static) Insert the plug into the power supply, turn on the power switch that comes with the device, and then select the 'File' item on the touch screen. Select a system original graphic in the file and let the automatic dispenser perform a motion test based on this graphic. The flexibility of the testing equipment to perform various actions. (It should be noted here that during the test, do not open the "allow firing" item on the control screen because this item is the switch that controls the system to give glue).

气缸 都是小的方形气缸,这种气缸所需要的理想气压为0.6MP不宜调的过大,气压过大得话容易导致气缸运动过猛,而影响气缸的使用寿命。 3.The next step is to connect the air pipe and the rubber pipe. The nod control cylinders configured by most automatic dispensers are small square cylinders. The ideal air pressure required for this type of cylinder is 0.6MP. It should not be adjusted too much. If it is too large, it will cause the cylinder to move too fast, which will affect the service life of the cylinder. The pressure of the plastic tank is between 0.6 and 0.8mp. (The gas entering the plastic tank must be pure air after air filtration and oil-water separation, otherwise it is easy to cause the glue to deteriorate and also easily rust some hardware of the equipment.) The dispensing tube is connected to the nod of the automatic dispenser, and the takeover work is basically completed.
  
Second, the use of the machine:
This is the most worthy of our attention, so how to regulate the use of this automatic dispenser? First of all, when using the device, pay attention to it. Do not directly touch the touch screen with a hard object for convenience. This directly affects the life of the touch screen and Touch screen sensitivity. When the equipment is running, it is not allowed to artificially prevent the nodding movement track with external force. Also note that the distance between the nodding and the work surface should not be too close or too far to maintain 20CM is the best distance.

Three, matters needing attention:
Before running the equipment, first check whether there are any debris on the running tracks on both sides and the horizontal track tracks.If necessary, you must clean up the running equipment. Check whether the equipment nods with dry glue attached to it. Otherwise, the effect of a gun shot will be directly affected and a nod will be blocked. 防锈油 止活动部件生锈影响下次使用的灵敏度。 After using the equipment, it is best to use Tianna water or the cleaning solution provided by the equipment supplier to clean the nod of the equipment. There must be no residue on the nod. The next time it is used, it is smooth. Every moving part must be coated with anti-rust oil to prevent the moving parts from rusting and affecting the sensitivity of the next use.

This article is divided into 1 pages
share to:
Previous: How to choose the correct soldering iron tip of automatic soldering machine
Next: No more

related information